VanZant 48 Posted December 10, 2015 I play SP only so if there is a problem with MP I can't make tests (and don't want to waste time).On other hand, although it can be done modifying the provided userconfig, the intention of this addon is to make adjustments in a easy way, not remove everything. To work well is necessary to configure properly the userconfig folder. Share this post Link to post Share on other sites
ineptaphid 6413 Posted December 31, 2015 Hey VanZant-if anyone could do this it would be you :) Would it be possible to add an extra command-like you did with copymystance- which would act in this way- When you tell AI to go move to a spot,they move there and freeze in place.this is really annoying as there may be cover beside them but they wont use it as you told them to move "here". So what I want is a command to tell them to move to a general area-say a few square metres in size-that would mean they could get in or out of cover yet stay at roughly the point you sent them to. Is that at all possible?I ask you because yours is the only mod I have seen that adds an extra AI command. Share this post Link to post Share on other sites
VanZant 48 Posted December 31, 2015 Hey VanZant-if anyone could do this it would be you :) Would it be possible to add an extra command-like you did with copymystance- which would act in this way- When you tell AI to go move to a spot,they move there and freeze in place.this is really annoying as there may be cover beside them but they wont use it as you told them to move "here". So what I want is a command to tell them to move to a general area-say a few square metres in size-that would mean they could get in or out of cover yet stay at roughly the point you sent them to. Is that at all possible?I ask you because yours is the only mod I have seen that adds an extra AI command. Select some units and in the command menu nº1 use "Move to point". The units will move to the specific point, not spreaded due to formation. Here 1 Share this post Link to post Share on other sites
ineptaphid 6413 Posted January 3, 2016 Select some units and in the command menu nº1 use "Move to point". The units will move to the specific point, not spreaded due to formation. Here thanks mate -just used "move to point now-it's great :D With regard to steady shot,does anyone who uses ace know what values to put into steadyshot that would be similar to ace recoil? I want to stop using ace,but I really like it's recoil :) Share this post Link to post Share on other sites