ph00nix 10 Posted November 24, 2009 hey, I made a map in Wilbur. Then I noticed that I can t reload it properly, the new apprerance is not usable at all: left:the one I made, right: the one wilbur loads I saved in almost all formats until it finally crashed. Share this post Link to post Share on other sites
cross 1 Posted November 25, 2009 I believe it is just the coloring scheme ... Share this post Link to post Share on other sites
ph00nix 10 Posted November 25, 2009 ok, and where can I adjust that ? Share this post Link to post Share on other sites
ceeeb 147 Posted November 25, 2009 IIRC, wilbur scales the colours it uses to present the height data evenly between the highest/lowest points used in the terrain during the given session. There is an option somewhere to redraw, which resets the colours evenly over the current heights of the terrain (when you reload, wilbur is doing this). The actual data is not changing, only the colour gradients that help the user visualise it. Share this post Link to post Share on other sites
ph00nix 10 Posted November 27, 2009 there is a grayscale shader that restores the info, thx guys Share this post Link to post Share on other sites
