anguis 4 Posted October 2, 2008 Hi, folks, After hunting around on the web for some performance tips, I ran into one about changing, in your BIOS (memory options, I think), the Command Rate from 2T to 1T (or, optionally, set the 2T Command to Disabled). I tested a bit with Kegetys' D3D bandwidth tester and saw an improvement. I did further testing in the FDF mod with a mission that always bogged down at a particular point (I run it w/ dxdll, high terrain detail, 1600x1200, etc. . .) and noticed improvement there (no bogging down), as well. So, I have to say that I'm happy with the adjustment! Here're some links to relevant info: TechARP 2T Command page Kegetys' D3D Bandwidth tester I hope this can help some of you! Share this post Link to post Share on other sites