WebDog 0 Posted November 19, 2001 What parameters do you set units so that they start IN a vehicle that you designate? Share this post Link to post Share on other sites
Hidden 0 Posted November 19, 2001 Init field: unitname movenincargo unit unitname = your unit (soldier) unit = where they are supposed to be when the mission starts. I am not sure whether you have to group them. I have just tried, did it like this: Put a Jeep on the map. Typed "Jeep1" in the name field Put 3 soldiers on the ground next to the Jeep. In each soldiers init field I typed: Alpha=GroupThis; moveincargo Jeep1 Then they were inside the Jeep when the mission started. Hope this helps. Hidden Share this post Link to post Share on other sites
vitoal125 0 Posted November 20, 2001 if none goes to be the driver, on one of the fields be sure to type this moveindriver jeep1 Share this post Link to post Share on other sites
Space Cadet 1 Posted November 20, 2001 If the blokes are in the same group as the transport you can just set their SPECIAL field to in cargo. If you dont want them in the same group as the transport you need to use the moveincargo command as Hidden suggested. Share this post Link to post Share on other sites