Hi all I am working on my 6th and final island for arma2 its north waziristan i have had it in game at 10km x 10km and thought it was to small, so i upped it to 20 km x 20 km but hear comes my problems
sat and mask are 20480 x 20480
terrain cell 10
I load the sat and mask in to visitor and load in my xyz and save it, I then open bulldozer and it converts the png to paa for sat and mask, bulldozer then opens and my textures show fine in bulldozer so i binerized it to go in game.
I then get the error no textures are found for sat and mask and in game island is white , so I checked my layers folder and nothing is in there even though it converted them so i have tried a few times but still no layers a pear in the folder.
I have installed visitor to another hard drive as i thought visitor was messing about, it does the same in the new installed visitor my folder structure is the same as my 5 previous islands so i am at a loss to know where these layers have gone to and why bulldozer shows them even though there not in the folder
i have searched for an answer on the forums but came up with no results could i get some advice off any 1 that has had the same problem or knows the answer cheers all if you can help
this is going to be a clafghan makes love to sangin type terrain terraced mountains with green zone in the lower vallys
here's a youtube vid of the 10x10 that works http://www.youtube.com/watch?v=dAw4HLJ_KQI