How to use Artillery as gunner

[last_rifle_round]

I've seen videos on youtube showing a map with targeting reticule for artillery, but when I use the "Target artillery" option, I seem to only get a map with no cursor. What am I doing wrong?

[SpetS15]

You have to aim very high to see the reticule on the map. And the center of that reticule is where it going to hit mostly

[Muahaha]

It's not that user friendly currently, you need to adjust and aim once you bring up the "arty map" when you are in the gunner's position. Hopefully it will be greatly enhanced once BAF is out.

[Kristian]

C'mon! Its as user friendly as can be!
Aiming with mouse on a map, how much MORE userfriendly can you make it?

[NouberNou]

Point and boom... :P


Yea, I think for the arty module anything below 30 degrees elevation it wont show, so remember to always aim your gun very high (the arty module only handles high angle solutions).

Also the lines do mean something and it is very important! The center line is the 0 altitude difference line. If the target is above or below you, then you need to compensate by using one of the lines between the extremes to aim. If you fire at a target that is much higher than you or lower than you just on the center line then its going to fall far or short of the target.