Page 3 of 3 FirstFirst 123
Results 21 to 27 of 27

Thread: Aaep

  1. #21
    Gunnery Sergeant
    Join Date
    Jan 6 2002
    Location
    Bremen, D, EU
    Posts
    431
    Author of the Thread
    I made the version with 14,5mm MG. The BTR-80 (14,5mm + 7,62mm) was introduced in 1984. So it will fit into the timeline of the game. The BTR-80A, which has the 30mm Cannon, was introduced in 1994 as far as I know. So it's too new for the game.

    Till later, PSC

  2. #22
    Gunnery Sergeant
    Join Date
    Jan 6 2002
    Location
    Bremen, D, EU
    Posts
    431
    Author of the Thread
    <OBJECT CLASSID="clsid27CDB6E-AE6D-11cf-96B8-444553540000" WIDTH=200 HEIGHT=50><PARAM NAME=MOVIE VALUE=http://dm.hfk-bremen.de/PSC/btr-80/btr-80_ingame.swf><PARAM NAME=PLAY VALUE=TRUE><PARAM NAME=LOOP VALUE=TRUE><PARAM NAME=QUALITY VALUE=HIGH><EMBED SRC=http://dm.hfk-bremen.de/PSC/btr-80/btr-80_ingame.swf WIDTH=200 HEIGHT=50 PLAY=TRUE LOOP=TRUE QUALITY=HIGH></EMBED></OBJECT>



    Just to keep you up to date

    Till later, PSC




  3. #23
    Staff Sergeant
    Join Date
    Sep 11 2001
    Location
    Izola, Slovenia
    Posts
    227
    Some info about BTR-80 and its versions:

    BTR-80 Armored Personnel Carrier

    The BTR-80 is the successor to the BTR-70 and has several significant improvements over the earlier wheeled APCs. The BTR-80 retains the same, boat-shaped hull front, and sloped sides, although the rear deck has been reconfigured by raising the rear and squaring off the rearward-sloping engine compartment. The side-half doors of the BTR-70 have been replaced by full side doors, and the firing ports have been modified to face forward. The BTR-80 has a hull of all-welded steel armor construction. The twin gas engines of the BTR-70 have been replaced by a single, more-powerful diesel engine which give the BTR-80 better performance and lower the risk of fire. The turret, which is similar to that on the BTR-60PB and BTR-70, is armed with the 14.5-mm KPV heavy machine gun and coaxial 7.62-mm PKT machine gun. This turret is improved in that it can be elevated to +60 degrees compared to the +30 degrees of earlier vehicles. The sighting system for the machineguns is improved as well. There are six 81-mm smoke mortars mounted on the rear of the turret which can be fired from inside the vehicle. The full side doors of the BTR-80 are positioned between the second and third axles of the vehicle. Each side door consists of an upper half which opens forward, and the lower half which opens down and forms a step ladder for troops entering or exiting. The upper half of the door is also fitted with a firing port. The crew of the BTR-80 consists of a commander, gunner and driver, and can carry seven infantry men. There are three forward-facing firing ports along the length of the hull, one at the front of the vehicle for the commander, and two in the roof hatches. The front two firing ports are designed for the 7.62-mm PK general purpose machine guns. The remaining firing ports are designed for AKMS/AK-74 individual weapons. The BTR-80 is fully amphibious and has a front-mounted winch, overpressure NBC system, night vision equipment and a central tire-pressure regulation system.

    VARIANTS:

    BTR-80K This is the commander&#39;s variant of the BTR-80, and is equipped with an 11 meter telescopic mast. The vehicle enables the commander of a motorized rifle battalion to control his unit and maintain communications with the regimental commander. For this purpose it is fitted with two R-163-50U VHF radio sets, two R-159 remote VHF radio sets, and a TNA4-6 type navigational device with an indicator board.

    BTR-80UNSh The UNSh variant of the BTR-80 was developed as a common base for command and staff duties, for fire control and radar vehicles as well as for mobile radio communication posts. With a wider and raised superstructure, the vehicle gives greater space for operators and additional equipment.

    BTR-80 Medical Vehicles The BTR-80UNSh vehicle has been adapted to a series of medical vehicles. BMM-1 is a medical evacuation vehicle, BMM-2 is a battalion medical station, and the BMM-3 is a mobile dressing station with a team of doctors and an AP-2 set of equipment. Up to four casualties on stretchers can be carried inside the hull, and an additional 12 can be housed in an attached tent.

    RKhM-4 Chemical and reconnaissance vehicle.

    2S23 Self-Propelled 120-mm Combination Howitzer-Mortar Available details of this are given in the Self-Propelled guns and howitzers section.

    BTR-80A This vehicle incorporates a new turret system which is referred to as the modular weapon station (MWS). The MWS is of all welded steel construction. Mounted externally on the top of the turret is the same 30-mm 2A42 cannon that is fitted to the BMP-2. A PKT 7.62-mm machine-gun is mounted coaxially to the right of the 30-mm cannon. Mounted on either side of the cannon is a bank of three 81-mm electrically operated, forward firing smoke grenade launchers. Turret traverse is through 360? with weapon elevation being between -5 and +70?. Although it lacks the protection level of the BMP-2, the BTR-80A has the advantage of a higher road speed and range and, therefore greater strategic mobility.

    BREM-K The recovery version of the BTR-80 (8 x 8) APC is referred to as the BREM-K, although it also has the designation GAZ-59033. Standard equipment includes an A-frame, which, tow bars, small stowage platform to the turret rear and stabilizers under the nose of the vehicle. This vehicle is not armed.

    FlipeR

  4. #24
    Chief Warrant Officer Antichrist's Avatar
    Join Date
    Aug 23 2001
    Location
    Aotearoa
    Posts
    3,155
    That looks sweet&#33;&#33;&#33; IS it still classified? When is the release?

  5. #25
    Gunnery Sergeant
    Join Date
    Jan 6 2002
    Location
    Bremen, D, EU
    Posts
    431
    Author of the Thread
    He he AC, I fear it is still classified. I managed to get it in game yesterday, but it still has a lot of bugs that need to be wiped out. For instance, I need to fix those damn proxy positions for the crew/cargo. Befor I do that I should finish the interiour. It&#39;s about 85% done (I&#39;ve found some new pictures of the turret section and had to remodel the existing one I allready had). To get the vehicle ingame I used a config.cpp from a truck. That means it has no turret, no hatches, and the second steering axis does not work (same as with the scud, if you take a closer look at the second axis). These are all problems I have to solve before I can/will release it. And that mean probably still a lot of time before that happens.

    Till later, PSC

  6. #26
    Gunnery Sergeant Airwolf's Avatar
    Join Date
    Sep 1 2001
    Location
    California, USA
    Posts
    433
    Hey, that oil rig will be cool, will you be able to land on it? i noticed that in resistance you can land on top of the flat buildings now, maybee the same can be done for the rig and future ships.

  7. #27
    hi psc
    schreib mal bitte deine e-mail addy an
    hab ne frage wegen dem btr

Page 3 of 3 FirstFirst 123

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •