View Full Version : Join and Lead
Jun 9 2009, 22:13
Trying get an AI Captain to upon switched trigger, run over to the PC via Join and Lead command and allow him to take command of player. I've put the waypoint directly over the PC icon as well as tried to sync the PC to the waypoint but no luck.
Jun 9 2009, 22:40
Did you place the waypoint somewhere else then dragged it on the player or did you place it on the unit itself so it became locked on the unit in the editor? Only the second situation will result in it activating properly (At least it did in ArmA1).
Alternatively if you're using triggers anyways, you might want to use the join command (http://community.bistudio.com/wiki/join).
Jun 9 2009, 22:50
Yep, I was dragging it as you said but putting the WP directly on player activated it.
Thanks good stuff.
Powered by vBulletin® Version 4.2.0 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.