Cannot create 3d device

[pide2020]

ha all, i justy tried changing res so i can see more in O2 (didnt happen as my monitor doesnt support anything higher than 1024 etc) now all settings are bck to normal, but i get this error when starting O2, or more specifically when bulldozer loads (same error when i try to load OFP resistance):
"cannot create 3d device
adaptor 0 (NVIDIA Gforce 2 Ti) windowed
resolution 849 x 481, format x8r8g8b8/d24s8, refresh 0 hz
ERROR E_OUTOFMEMORY"

Then the ok button, so O2 is there, but no bulldozer
what have i done?

[pide2020]

slightly different error when loading flappo;

"cannot create 3d device
adaptor 0 (NVIDIA Gforce 2 Ti) windowed
resolution 1024 x 768, format x8r8g8b8/d24s8, refresh 75 hz
ERROR E_OUTOFMEMORY"

[pide2020]

never mid, a reinstall of nvidia drivers fixed it

cheers

[VXR]

if you used the search function you would know that its posible to fix by copying the flashpoint.cfg from ofp to your buldozer directory http://www.flashpoint1985.com/ikonboard301/iB_html/non-cgi/emoticons/smile.gif

[pide2020]

i did search honest! :-)